CBSE Class 12 Chemistry Notes – Surface Chemistry

Surface Chemistry is the branch of chemistry which deals with the phenomenon that occurs on the surfaces or interfaces, such phenomenon includes corrosion. catalysis, crystallization, etc

Due to unbalanced attraction forces, accumulation of molecular species at the surface rather than in the bulk of a solid or liquid is termed as adsorption. The molecular species accumulates at the surface is termed as adsorbate and the material on the surface of which the adsorption takes place is called adsorbent, e.g..

(i) O2, H2, C12, NB3 gases are adsorbed on the surface of charcoal.

(ii) Silica gels adsorb water molecules from air.

Charcoal, silica gel, metals such as Ni, Cu, Ag, Pt and colloids are some adsorbents.

1. It is specific and selective in nature.

2. Adsorption is spontaneous process, therefore change in free energy (ΔG)is negative.

ΔG= ΔH – TΔS,

For the negative value of ΔG,in a system, in which randomness decreases, ΔH must be negative. Hence, adsorption is always exothermic.

Adsorption of hydrogen over Pt is called occlusion.

It is a process of removing an adsorbed substance from a surface on which it is adsorbed, is known as desorption.

It is a process in which both adsorption and absorption take place simultaneously, the term sorption is simply used.

When the concentration of the adsorbate is more on the surface of the adsorbent than in the bulk, it is called positive adsorption.

On the other hand, if the concentration of the adsorbate is less relative to its concentration in the bulk, it is called negative adsorption, e.g., when a dilute solution of KCl is shaken with blood charcoal, it shows negative adsorption.

(a) Nature of adsorbent Same gas may be adsorbed to different extents on different adsorbent.

(b) Surface area of the adsorbent Greater the surface area, greater is the extent of adsorption.

(c) Nature of the gas being adsorbed Greater is the critical temperature of a gas, greater are the van der Waals’ forces of attraction and thus, greater is the adsorption.

(d) Temperature Adsorption is an exothermic process involving the equilibrium

Gas (adsorbate) + Solid (adsorbent) ⇔ Gas adsorbed on solid + Heat

Applying Le-Chatelier principle, increase of temperature decreases the adsorption and vice-versa.

(e) Pressure Adsorption increases with pressure at constant temperature. The effect is large if temperature is kept constant at low value.

(f) Activation of the solid adsorbent Activation means increasing the adsorbing power of the solid adsorbent. This can be done by subdividing the solid adsorbent or by removing the gases already adsorbed by passing superheated steam.

It is the plot of the mass of gas adsorbed per gram of adsorbent (x / m) versus equilibrium pressure at constant temperature.

It gave an empirical relationship between the quantity of gas adsorbed by unit mass of solid adsorbent and pressure at a particular temperature. It can be expressed by the equation.

x / m = kp1/n …(i)

Where, x is the mass of the gas adsorbed on mass m of the adsorbent at pressure p, k and n are constants which depend on the nature of the adsorbent and the gas at a particular temperature.

At low pressure, n = 1, i.e., x / m = kp

At high pressure, n > 1, i.e., x / m = k (independent of p)

Taking logarithm of Eq. (i)

x / m = kC1/n

where, C is the equilibrium concentration. On taking logarithm of the above equation, we have

According to Langmuir, the degree of adsorption is directly ProPOrtional to e, i.e., the fraction of surface area occupied.

x / m α θ = kθ

These are plots of x / m us temperature t at constant pressure. For physical and chemical adsorption, they are shown below.

These are the plot of temperature versus pressure for a given amount of adsorption

Catalyst is a chemical substance which can change the rate of reaction without being used up in that reaction and this process is known as catalysis

A catalyst may be positive (i.e., increases rate of reaction) or negative (i.e., decreases rate of reaction).

(a) Homogeneous catalysis In this catalysis, and the catalyst reactants are in the same physical state [phase], e.g.,

(b) Heterogeneous catalysis In heterogeneous catalysis, catalyst is present in a different phase than that of reactants, e.g.,

(c) Autocatalysis When one of the product of a reaction acts as catalyst, the process is called autocatalysis.

1 The catalyst remains unchanged in mass and chemical composition.

2. In case of reversible reactions, the catalyst does not influence the composition of reaction mixture at equilibrium. It only helps to attain the equilibrium quickly.

Promoters are chemical substances that enhance the activity of a catalyst while poisons decreases the activity of a catalyst

The mechanism involves five steps:

(i) Diffusion of reactants to the surface of the catalyst

(ii) Adsorption of reactant molecules on the surface of the catalyst.

(ill) Occurrence of chemical reaction on the catalyst’s surface through formation of an intermediate.

(iv) Desorption of reaction products from t he catalyst surface.

(v) Diffusion of reaction products away from the catalyst’s surface

(i) Activity The activity of a catalyst depends upon the strength of chemisorption to a large extent. The adsorption should be reasonably strong but not so strong that they become immobile and no space is available for other reactants to get adsorbed.

(ii) Selectivity The selectivity of a catalyst is its ability to direct a reaction to yield a particular product, e.g., starting with Hz and CO using different catalysts, we get different products.

Shape–selective catalysis The catalytic reaction that depends upon the pore structure of the catalyst and the size of the reactant and product molecules is called shape-selective catalysiS. Cracking Isomerization of hydrocarbons in the presence of zeolites is an example of shape-selective catalysis.

An important zeolite catalyst used in the petroleum industry is ZSM-S.lt converts alcohols directly into gasoline.

Enzymes are complex nitrogenous organic compounds which are Produced by living plants and animals. They are actually protein molecules of high molecular mass and form colloidal solutions in water.

They are also known as biochemical catalysis.

Some examples of enzyme catalysed reactions are:

(Source of invertase, zymase and maltose is yeast and that of diastase is malt. Soybean is the source of urease.)

(v) In stomach, the pepsin enzyme converts proteins into peptides while in intestine, the pancreatic trypsin converts proteins into amino acids by hydrolysis.

(vi) Lactobacilli is used to convert milk into curd.